Cub Cadet Z-Force S Series User Manual
Page 43
Drive
37
14.
Support the transmission to prevent it from falling
while the mounting bolts are removed.
15.
Remove the two bolts that fasten the transmission to
the frame. See Figure 5.21.
16.
Lower the transmission enough to gain access to the
by-pass rod.
17.
Remove the hair pin clip that secure the by-pass rod
to the by-pass lever. See Figure 5.14.
18.
Lift the by-pass rod off of the by pass lever.
19.
Remove the transmission from the mower.
NOTE: If replacing the transmission, Inspect the vent
hose. If it is in good condition remove it from the
old transmission and install it on the new transmis-
sion. If it cracked, brittle or damaged, install a new
vent hose on the new transmission.
20.
Install the transmission by following the previous steps in reverse order.
NOTE: Before lowering the mower to the ground purge the transmission by:
•
Move the by-pass rod to the by-pass position.
•
Start the engine.
•
Cycle the drive pedal from full toward to full reverse six times.
•
Move the by-pass rod to the drive position.
•
Cycle the drive pedal from full forward to full reverse six times.
NOTE: Removal of the brake caliper will make installing the transmission easier, but is not required.
21.
Perform a neutral adjustment and wheel alignment by following the steps described in 6: Steering.
22.
Test drive the mower before returning it to service.
Figure 5.21
Transmission mount
bolts
Figure 5.22
By-pass rod