Cub Cadet Yanmar 3TNV72 - Manual (Page 139)

ENGINE
6-40 TNV IDI Service Manual
Cylinder Block
4. Do not remove the fuel injection pump drive
gear unless absolutely necessary due to
damage to the gear or pump. Do not loosen or
remove the four bolts (Figure 6-43, (3))
retaining pump drive gear to the hub. Only
remove the nut (Figure 6-43, (1)) and washer
(Figure 6-43, (2)), leaving the hub attached to
the gear. Remove the pump drive gear and hub
as an assembly using a gear puller.
Figure 6-43
Removal of Oil Pan
1. Invert the engine (oil pan up) on the engine
stand.
2. Remove the oil pan (Figure 6-44, (2)).
3. Remove the crankcase extension
(Figure 6-44, (1)) if equipped.
Figure 6-44
4. Remove the oil pickup tube (Figure 6-45, (1))
and O-ring (Figure 6-45, (2)).
Figure 6-45
CAUTION
Do not loosen or remove the four bolts
retaining the fuel injection pump drive
gear to the fuel injection pump hub. Do
not disassemble the fuel injection pump
drive gear from the hub. Correct fuel
injection timing will be very difficult or
impossible to achieve.
0000031en
0002183
(1)
(3)
(2)
0002184
(2)
(1)
0002185
(2)
(1)
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 40 ページ ２００７年１１月２９日 木曜日 午後２時５８分