Cub Cadet Yanmar 3TNV72 - Manual (Page 231)

STARTER MOTOR
10-18 TNV IDI Service Manual
Starter Motor
8. Reinstall the plate onto the intermediate
housing and carefully reinstall the armature
assembly (Figure 10-31, (2)) into the pinion
shaft assembly.
Figure 10-31
9. Reinstall the field assembly (Figure 10-31, (3))
over the armature assembly and align to the
pinion housing.
10. Position the brush springs in brush holders.
Reinstall the brushes in the brush holders.
Reversing the brushes will cause the starter
motor to turn backwards.
11. Carefully reinstall the brush holder
(Figure 10-32, (3)) assembly.
12. Reinstall the rear cover (Figure 10-32, (2)) and
secure with two bolts (Figure 10-32, (1)).
Figure 10-32
13. Reinstall the two through bolts and tighten
securely.
14. Reinstall the return spring (if equipped)
(Figure 10-33, (3)) on the solenoid plunger
(Figure 10-33, (4)). Reinstall the solenoid
switch coil (Figure 10-33, (1)) and dust covers
(Figure 10-33, (2)). Secure with nuts or bolts.
Figure 10-33
15. Reconnect the wire to the solenoid switch
assembly. Tighten the nut. Reinstall the cover
over the connection.
Figure 10-34
(2) (1)
(3)
0000144A
(1)
(2)
(3)
0000142A
(4)
(2)
(3)
(1)
0000140A
0000138
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 18 ページ ２００７年１１月２９日 木曜日 午後２時５８分