Cub Cadet Yanmar 3TNV72 - Manual (Page 222)

STARTER MOTOR
TNV IDI Service Manual 10-9
Starter Motor
1 – Nut
2 – Needle Bearing
3 – Pinion Housing
4 – Pinion Retaining Ring
5 – Pinion Stop
6 – Pinion
7 – Shift Lever
8 – Solenoid Switch Assembly
9 – Snap Ring
10 – Washer
11 – Bushing
12 – Intermediate Housing
13 – Reduction Gear
14 – Washer
15 – Through Bolt
16 – End Housing
17 – Brush Plate and Holder
18 – Field Assembly
19 – Armature
20 – Bushing
21 – Plate
22 – Planetary Gear (3 used)
23 – Washer (3 used)
24 – Pinion Shaft
STARTER MOTOR
Note: While starter motor design varies
between models, the basic repair
procedures are the same. The following
procedures are typical and may differ
from the starter being serviced.
A
WARNING
SHOCK HAZARD!
• Turn off the battery switch (if
equipped) or disconnect the negative
battery cable before servicing the
electrical system.
• Check the electrical harnesses for
cracks, abrasions, and damaged or
corroded connectors. ALWAYS keep
the connectors and terminals clean.
• Failure to comply could result in death
or serious injury.
0000009en
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 9 ページ ２００７年１１月２９日 木曜日 午後２時５８分