Cub Cadet Yanmar 3TNV72 - Manual (Page 249)

ALTERNATOR
11-16 TNV IDI Service Manual
Alternator
Figure 11-18
11. Reassemble the pulley (Figure 11-18, (2)) and
nut (Figure 11-18, (1)) to the shaft of the rotor
assembly. Tighten the nut.
Installation of Alternator
1. Position the alternator on the gear case.
Loosely reinstall the nut (Figure 11-19, (2)) on
the gear case stud and the V-belt adjuster bolt
(Figure 11-19, (1)).
Figure 11-19
2. Reconnect the electrical wires to the alternator.
Tighten the nuts to 15 - 20 in.-lb (1.7-2.3 N·m;
17-23 kgf·m).
3. Reinstall the V-belt. Tighten the V-belt to the
proper tension. See Check and Adjust Cooling
Fan V-Belt on page 5-27.
4. Start the engine. Listen for any unusual sounds
from the alternator.
5. Verify that the charge indicator is ON while the
engine is operating. If the charge indicator is
not ON, repair the problem before operating the
engine.
0000256
1
2
1 2
0000264
CAUTION
Do not operate the engine if the
alternator is producing unusual sounds.
Damage to the alternator will result.
0000039en
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 16 ページ ２００７年１１月２９日 木曜日 午後２時５８分