Cub Cadet Yanmar 3TNV72 - Manual (Page 57)

GENERAL SERVICE INFORMATION
4-22 TNV IDI Service Manual
Tightening Torques for Standard Bolts and Nuts
TIGHTENING TORQUES FOR STANDARD BOLTS AND NUTS
Use the correct amount of torque when you tighten
fasteners on the machine. Applying excessive
torque may damage the fastener or component and
not enough torque may cause a leak or component
failure.
CAUTION
The tightening torque in the Standard
Torque Chart in General Service
Information should be applied only to
the bolts with a “7” head. (JIS strength
classification: 7T)
• Apply 60% torque to bolts
that are not listed.
• Apply 80% torque when
tightened to aluminum alloy.
0000023enTNVIDISM
Item
Nominal Thread
Diameter
x Pitch Tightening Torque Remarks
Hexagon Bolt (7T)
and Nut
M6 x 1.0 mm
87 - 104 in·lb
(9.8 - 11.8 N·m;
1.0 - 1.2 kgf·m)
Use 80% of the value at left
when the tightening part is
aluminum.
Use 60% of the value at left
for 4T bolts and lock nuts.
M8 x 1.25 mm
200 - 251 in·lb
(22.6 - 28.4 N·m;
2.3 - 2.9 kgf·m)
M10 x 1.5 mm
33 - 40 ft·lb
(44.1 - 53.9 N·m;
4.5 - 5.5 kgf·m)
M12 x 1.75 mm
58 - 72 ft·lb
(78.4 - 98.0 N·m;
8.0 - 10 kgf·m)
M14 x 1.5 mm
94 - 108 ft·lb
(127.5 - 147.1 N·m;
13 - 15 kgf·m)
M16 x 1.5 mm
159 - 174 ft·lb
(215.7 - 235.4 N·m;
22 - 24 kgf·m)
PT Plug
1/8 mm
87 in·lb
(9.8 N·m; 1.0 kgf·m)
-
1/4 mm
173 in·lb
(19.6 N·m; 2.0 kgf·m)
3/8 mm
22 ft·lb
(29.4 N·m; 3.0 kgf·m)
1/2 mm
43 ft·lb
(58.8 N·m; 6.0 kgf·m)
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 22 ページ ２００７年１１月２９日 木曜日 午後２時５８分