Cub Cadet Yanmar 3TNV72 - Manual (Page 233)

STARTER MOTOR
10-20 TNV IDI Service Manual
Starter Motor
5. Install a switch (Figure 10-37, (6)) in a circuit
between the battery positive (+) terminal
(Figure 10-37, (2)) and the starter solenoid
switch terminal (Figure 10-37, (8)) on the
starter motor.
6. Use a suitable tachometer to monitor the rpm of
the starter.
7. Turn the switch to the ON position to energize
the solenoid and operate the starter. Monitor
the rpm, amperage draw and voltage. For test
specifications, see Starter Motor Information on
page 10-5 for the appropriate starter motor.
Installation of Starter Motor
1. Reinstall the starter motor to the flywheel
housing.
2. Reinstall the starter mounting bolts
(Figure 10-38, (1)). Tighten the bolts to
specification. See Tightening Torques for
Standard Bolts and Nuts on page 4-22.
Figure 10-38
3. Reconnect the electrical wires to the solenoid
switch assembly. Be sure to place the cover
over the battery positive (+) cable connection.
4. Reconnect the battery, negative (-) cable last.
(1)
0002126
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 20 ページ ２００７年１１月２９日 木曜日 午後２時５８分