Cub Cadet Yanmar 3TNV72 - Manual (Page 145)

ENGINE
6-46 TNV IDI Service Manual
Cylinder Block
11. Remove the crankshaft from the engine.
12. Remove the bearing inserts (Figure 6-59, (1))
and thrust bearings (Figure 6-59, (2)).
Note: Do not remove the crankshaft gear
unless the gear or crankshaft are
damaged and require replacement.
Figure 6-59
13. If necessary, remove the crankshaft gear
(Figure 6-60, (1)) and key (Figure 6-60, (2)). If
using a gear puller, be careful not to damage
the threads in the end of the crankshaft.
Figure 6-60
Inspection of Crankshaft and
Camshaft Components
Thoroughly clean all components using a brush
and appropriate solvent. Each part must be free of
carbon, gasket material, metal filings and other
debris.
Note: Record all measurements taken during
inspection.
Replacement of Crankshaft Oil Seals
1. Remove the seal (Figure 6-61, (2)) from the
gear case cover (Figure 6-61, (1)).
2. Apply a continuous bead of ThreeBond Liquid
Gasket No. 1212, Yanmar Part No.
977770-01212 to the outside diameter of a new
oil seal (Figure 6-61, (2)).
3. Install a new seal in the gear case cover with
the lip facing in away from the crankshaft pulley.
Apply lithium grease to the lip of the seal.
(1)
(2)
0002189
(2)
(1)
0002193
A
WARNING
FUME / BURN HAZARD!
• Always read and follow safety related
precautions found on containers of
hazardous substances like parts
cleaners, primers, sealants and
sealant removers.
• Failure to comply could result in death
or serious injury.
0000014en
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 46 ページ ２００７年１１月２９日 木曜日 午後２時５８分