Cub Cadet Yanmar 3TNV72 - Manual (Page 49)

GENERAL SERVICE INFORMATION
4-14 TNV IDI Service Manual
Engine Oil
2. Change the engine oil after the first 50 hours of
operation and then every 250 hours thereafter.
3. Select the oil viscosity based on the ambient
temperature where the engine is being
operated. See the SAE Service Grade Viscosity
Chart (Figure 4-5).
4. Yanmar does not recommend the use of engine
oil “additives.”
Additional Technical Engine oil
Requirements:
The engine oil must be changed when the Total
Base Number (TBN) has been reduced to 1.0
(mgKOH/g) test method; JIS K-201-5.2-2 (HCI),
ASTM D4739 (HCI).
Engine Oil Viscosity
Select the appropriate engine oil viscosity based on
the ambient temperature and use the SAE Service
Grade Viscosity Chart in Figure 4-5.
Figure 4-5
Checking Engine Oil
1. Make sure engine is level.
2. Remove dipstick (Figure 4-6, (1)) and wipe with
clean cloth.
3. Fully reinsert dipstick.
4. Remove dipstick. The oil level should be
between upper (Figure 4-6, (2)) and lower
(Figure 4-6, (3)) lines on the dipstick.
5. Fully reinsert dipstick.
Figure 4-6
Adding Engine Oil
1. Make sure engine is level.
2. Remove oil cap (Figure 4-6, (4)).
3. Add indicated amount of engine oil at the top or
side engine oil filler port (Figure 4-6, (5)).
4. Wait three minutes and check oil level.
5. Add more oil if necessary.
6. Replace oil cap (Figure 4-6, (4)) and
hand-tighten. Over-tightening may damage the
cap.
-4°F 14°F 32°F 50°F 68°F 86°F 104°F
(-20°C) (-10°C) (0°C) (10°C) (20°C) (30°C) (40°C)
SAE 10W
SAE 20W
SAE 10W-30
SAE 15W-40
SAE 20
SAE 30
SAE 40
0000005A
SAE 20W - 50
122°F
(50°C)
(4)
(5)
(1)
0000587C
(4)
(2)
(3)
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 14 ページ ２００７年１１月２９日 木曜日 午後２時５８分