Elektron Machinedrum - Manual (Page 108)

A-12 Appendix A: MACHINE REFERENCE
MID
The MIDI machines are used for controlling
external MIDI gear, such as synthesizers, con-
nected to the MIDI OUT port of the Machine-
drum. There are 16 MIDI machines in total,
each connected to the corresponding MIDI
channel. As there is no internal audio process-
ing fo these machines, their controls extend
over the SYNTHESIS, EFFECT and ROUT-
ING menus.
Synthesis window
NOTE - Selects the MIDI note to be triggered, ranging from
C-2 to G8.
N2 - If N2 differs from 0 it adds a second note (chord) N2
number of semitones from NOTE.
N3 - If N3 differs from 0 it adds a second note (chord) N3
number of semitones from NOTE.
LEN - Sets the length of the notes.
VEL - Sets the velocity for NOTE, N2 and N3.
PB - Controls the Pitch bend settings.
MW - Controls the Modulation Wheel.
AT - Controls the channel After Touch.
Track effects window
CC1D - Selects the Control Change message to be con-
trolled by CC1V.
CC1V - Sets the value of the Control Change chosen in
CC1D.
CC2D - Selects the Control Change message to be con-
trolled by CC2V.
CC2V - Sets the value of the Control Change chosen in
CC2D.
CC3V - Sets the value of the Control Change chosen in
CC3D.
CC3D - Selects the Control Change message to be con-
trolled by CC3V.
CC4V - Sets the value of the Control Change chosen in
CC4D.
CC4D - Selects the Control Change message to be con-
trolled by CC4V.
Routing window
CC5D - Selects the Control Change message to be con-
trolled by CC5V.
CC5V - Sets the value of the Control Change chosen in
CC5D.
PCHG - Performs a Program Change message between 0
and 126.
LFOS - Controls the speed of LFO of the MIDI machine.
LFOD - Controls the depth of the LFO of the MIDI
machine.
LFOM - Controls the balance between the waveforms of
the LFO of the MIDI machine.
CTR
The control machines are used to automate
and making it easier to control the different
parameters of the sixteen available tracks as
well as offering control over the stereo mas-
ter effects. Note that you can use LFO’s
alongside the stereo master effect control
machines, but not with the other control
machines.
CONTROL ALL “CTR-AL”
This machine simultaneously controls the chosen
parameter or parameters for all 16 tracks. Manipulating
one parameter on the CTR-AL machine will affect the
corresponding parameter on all 16 tracks. Note that
CTRL-AL does not affect the MIDI machines or the
SYNTHESIS page of RAM RECORD machines. The
functionality of this machine is similar to the [FUNC-
TION] + DATA ENTRY knobs operation described on
page 37 . The major difference is that using this
machine, you can set trigs.
Synthesis window
This page controls the up to 8 available synthesis
parameters for every machine and track.