Elektron Machinedrum - Manual (Page 51)

THE PATTERN SEQUENCER
43
2. When you are in the track you wish to clear, press and hold [SCALE SETUP]. Then
press [PLAY] to clear the track. The message “CLEAR PAGE” will appear.
• The clear track page operation can be undone by holding the [SCALE KEY] and
pressing the [PLAY] key directly after the clear operation. The message “UNDO
PAGE” will be shown in the display.
PATTERN COPY
To copy the contents of a a pattern to another, follow the steps below.
1. Make sure you are not in GRID RECORDING mode, indicated by the <RECORD> LED
being unlit.
2. Select the source pattern. Hold [FUNCTION] while pressing [RECORD]. A message
“COPY PATTERN” will be shown in the display.
3. Change pattern to the destination where you wish to paste your pattern data by using the
[BANK] and [TRIG] keys.
4. Paste the data by pressing and holding [FUNCTION] and then pressing the [STOP] key.
The message “PASTE PATTERN” will be shown in the display.
• The pattern data that is copied consists of notes, the kit association (in
EXTENDED mode) and parameter locks.
• Pasting a pattern overwrites any previous notes, data and parameter locks.
• The copy pattern operation will copy the whole pattern including unsaved kit
changes.
• You can undo the paste operation by holding the [FUNCTION] key and pressing
the [STOP] key.