Elektron Machinedrum - Manual (Page 49)

THE PATTERN SEQUENCER
41
• The clear note lock operation can be undone by performing the clear note opera-
tion one more time. The message “UNDO NOTE LOCKS” will be shown in the dis-
play.
TRACK COPY
In GRID RECORDING mode, it is possible to copy the contents of one track to another.
1. Make sure you are in GRID RECORDING mode, indicated by the <RECORD> LED giv-
ing off a steady light. Select the source track using the SOUND SELECTION wheel.
2. Hold [FUNCTION] while pressing [RECORD] to copy the data in the track.The message
“COPY TRACK” will be shown in the display.
3. Select the destination track using the SOUND SELECTION wheel.
4. Paste the data by pressing and holding [FUNCTION] and then pressing the [STOP] key.
A message saying “PASTE TRACK” will be shown in the display.
• The track data that is pasted consists of notes, the machine association, LFO set-
tings and, if in EXTENDED mode, parameter locks. If the LFO is set to affect a
parameter on the same track it is remapped as it is pasted. If the LFO is set to
affect a parameter of another track the destination is kept but the LFO depth is set
to zero to avoid confusing results.
• Pasting a track overwrites any previous notes, data and parameter locks.
• The paste track operation can be undone by holding down the [FUNCTION] key
while pressing the [STOP] key. A message saying “UNDO TRACK” will be shown
in the display.
CLEAR TRACK
While in GRID RECORDING mode, it is possible to clear a track.
1. Make sure you are in GRID RECORDING mode. The <RECORD> LED should be lit.