Elektron Machinedrum - Manual (Page 91)

EARLY STARTUP MENU
83
EARLY STARTUP MENU
To access this menu, hold down the [FUNCTION] key while powering up the Machinedrum.
From here you can perform a variety of maintenance tasks. To choose the different alterna-
tives, press the corresponding [TRIG] key.
TEST MODE
To enter this mode, press the first [TRIG] key. If you have any trouble with your Machine-
drum and suspect it may be due to a hardware problem, perform this self test. Everything
should come up as shown below. If not, contact Elektron support.
Here you can also check that every button and knob work as intended. Press the buttons
and turn the knobs and the <SOUND SELECTION> LEDs should light up. If something
does not work as supposed, please contact Elektron Support.
EMPTY RESET
To perform this operation, press the second [TRIG] key. This reset will clear all kits, pat-
terns, songs and global settings. If you have a Machinedrum UW, an empty reset will still
retain the ROM samples in memory.
For +Drive equipped units, an empty reset will clear all kits, patterns, songs and global set-
tings of the Battery backed memory. No samples will be erased.
FACTORY RESET
To perform this operation, press the third [TRIG] key. This reset restores all patterns, kits,
songs and globals to the factory presets that was preinstalled when the Machinedrum orig-
inally shipped. For the Machinedrum UW, all ROM samples will also be reverted to the fac-
tory defaults.
For +Drive equipped units the Battery Backed Memory will be replaced by factory patterns,
kits, songs and global settings. The first Sample bank will be replaced with factory sam-
ples, given you have a UW version of the Machinedrum. The first Snapshot will be replaced
with factory patterns, kits, songs and global settings. No other Snapshots or Sample banks
on the +Drive will be affected.