Hangar 9 Pulse XT 60 ARF - Manual (Page 10)

10
 Step 3
Prepare the aileron servo by installing the grommets and
brass eyelets provided with the servo. Plug the aileron
servo into the receiver and use the radio system to center
the servo. Install a 180-degree servo horn onto the aileron
servo as shown.
 Step 4
Use side cutters to remove one of the arms from the
servo horn.
 Step 5
Use a 5/64-inch (2mm) drill bit to enlarge the outer hole
of the servo arm.
 Step 6
Secure a 6-inch (152mm) servo extension to the servo
lead using a commercially available connector or string.
Section 1: Aileron Servo Installation