Hangar 9 Pulse XT 60 ARF - Manual (Page 37)

37
Required Parts
• Fuselage assembly • Switch
• Receiver • Receiver battery
• Y-harness or two 3-inch (76mm) extensions
• Hook and loop strap (short)
Required Tools and Adhesives
• Foam rubber • Masking tape
 Step 1
Install the switch harness on the side of the fuselage. The
covering will have to be removed from the fuselage using
a hobby knife to expose the opening.
Note: A pre-cut opening for a smaller
switch harness is located near the
front of the cockpit of your model.
 Step 2
Wrap the receiver in foam to protect it from vibration.
Make the connections for any servos, extensions or
switches to the receiver.
 Step 3
Secure the receiver as shown using a hook and loop
strap. When using a remote receiver, attach the receiver
as described in the instructions provided with your radio
system, placing it as far away from the main receiver and
as high in the fuselage as possible.
Note: An antenna tube has been installed in
the fuselage between the servos to route the
receiver antenna to the rear of the fuselage.
 Step 4
Wrap the receiver battery in foam to protect it from
vibration. Secure the receiver battery as shown using
a hook and loop strap. The receiver battery can be
moved rearward in the fuselage to correctly balance your
aircraft if necessary.
Section 6: Receiver Installation