Hangar 9 Pulse XT 60 ARF - Manual (Page 26)

26
Special Steps for 4-Stroke Installation
The following steps are required to provide clearance
between the carburetor arm and engine mounting rail.
 Step 1
Loosen the setscrew securing the carburetor arm to
the carbutetor. Trace the arc of the arm onto the engine
mounting rail using a pencil.
 Step 2
Remove the engine mounting rail from the fuselage and
engine. Use a rotary tool and sanding drum to remove
the material from the engine mounting rail to provide
clearance for the carburetor arm.
 Step 3
Remove the carburetor arm from the carburetor. Use a
5/64-inch (2mm) drill bit to enlarge the outer hole in the
carburetor arm.
 Step 4
Slide the brass connector into the hole. The connector will
face outward as shown.
 Step 5
Secure the connector using the nylon connector backplate.
Section 4: Glow Engine and Cowling Installation