Hangar 9 Pulse XT 60 ARF - Manual (Page 20)

20
 Step 8
Use side cutters to remove one of the arms from the
servo horn.
 Step 9
Use a 5/64-inch (2mm) drill bit to enlarge the outer hole
of the servo arm.
 Step 10
Repeat Steps 7 through 9 to prepare the elevator servo.
Note the direction of the servo arm in relationship to the
rudder servo. The rudder and elevator servos are mirror
images of each other.
 Step 11
Install the rudder and elevator servos using the hardware
provided with the servos.
Section 3: Rudder and Elevator Installation