Hangar 9 Pulse XT 60 ARF - Manual (Page 38)

38
Required Parts
• Fuselage assembly • Canopy
• Wing panel (right and left) • Wing dowel (2)
• Wing tube
• Plywood wing bolt plate
• 1/4-20 x 2-inch nylon wing bolt (2)
• 1
3 /
16
-inch x 3/16-inch (81mm x 4.75mm)
aluminum anti-rotation pin
Required Tools and Adhesives
• Low-tack masking tape • Ruler
• 30-minute epoxy • Medium sandpaper
• Paper towel • Rubbing alcohol
 Step 1
Position the canopy on the fuselage. Trace the outline of
the canopy on the fuselage.
 Step 2
Use medium sandpaper to scuff the fuselage and canopy
where they contact each other. Use rubbing alcohol and a
paper towel to remove any debris from the gluing area.
 Step 3
Use canopy glue to secure the canopy to the fuselage.
Low-tack tape is suggested to keep the canopy in position
until the glue has fully cured.
Section 7: Canopy and Wing Installation