Hangar 9 Pulse XT 60 ARF - Manual (Page 12)

12
 Step 10
Tie a wheel collar to the end of a 12-inch (300mm) piece
of string. Lower the wheel collar into the opening for the
servo and allow it to fall through the wing, exiting the
opening at the root of the wing as shown below.
 Step 11
Tie the string that exits the servo opening to the servo
extension. Use the string to pull the servo lead through
the wing.
Hint: Use painter's tape to prevent the
extension from falling back into the wing.
Section 1: Aileron Servo Installation