Hangar 9 Pulse XT 60 ARF - Manual (Page 28)

28
 Step 12
Look carefully at the fuel tank to determine which tubes
are for the carburetor and vent. Also check the direction
of the vent line inside the fuel tank. The vent will face the
top of the fuselage when the fuel tank is installed. Use the
drawings below as a reference for the fuel lines.
Clunk
Vent Line
Top View
Side View
Vent Line (faces top of fuselage)
To Muffler
To Carburetor
 Step 13
Insert the fuel tank into the fuselage, noting that the vent
line faces toward the top of the fuselage.
 Step 14
Use a 5/64-inch (2mm) drill bit and pin drill to enlarge the
outer hole of a standard servo arm as shown.
 Step 15
Use side cutters to remove the excess arms from the
servo horn so they don't interfere with the operation of the
throttle servo.
Section 4: Glow Engine and Cowling Installation