Hangar 9 Pulse XT 60 ARF - Manual (Page 25)

25
 Step 4
Dill the locations for the engine mounting screws using a
drill and 11/64-inch (4.5mm) drill bit.
Hint: Using a drill press will guarantee the
holes are parallel to the mounting rails.
 Step 5
Secure the engine to the engine mounting rails using
8-32 x 1 1 /
4
-inch machine screws, four #8 washers and
four 8-32 lock nuts.
 Step 6
Use a 5/64-inch (2mm) drill bit to enlarge the outer hole
in the carburetor arm.
 Step 7
Slide the brass connector into the hole. The connector will
face outward as shown.
 Step 8
Secure the connector using the nylon connector backplate.
Section 4: Glow Engine and Cowling Installation