Hangar 9 Pulse XT 60 ARF - Manual (Page 9)

9
Required Parts
• Wing panel w/ailerons (right and left)
• Servo w/hardware (2)
• 6
1 /
4
-inch (89mm) aileron linkage (2)
Required Tools and Adhesives
• Drill • Thin CA
• Phillips screwdriver • 180-degree servo arm
• Drill bit: 5/64-inch (2mm)
 Step 1a
Check to make sure the hinges have been securely glued
into place. Gently pull on each aileron to make sure the
hinges are secure. Avoid too much pressure which could
cause damage to the wing and aileron.
 Step 1b
If any hinges are found to be loose, apply thin CA to the
top and bottom of the loose hinge to secure its position.
 Step 2
Flex each aileron up and down a number of times to
break in the hinges.
Note: Do not use accelerator when gluing
hinges. The CA must be allowed to cure
naturally so it can soak into the hinge,
Section 1: Aileron Servo Installation