A&D Weighing SV-100H - Manual (Page 28)

26
5-4 After Use (For all models)
Remove any residual sample material from the sensor plates, temperature sensor and
protector using alcohol. Using the sensor plates, temperature sensor and protector with
residue of an old sample left on will cause a measurement error.
Clean the sensor plates carefully to avoid bending them.
The sensor plates and the temperature sensor are made of titanium.
How to clean the sensor plates and temperature sensor
SV-1A/SH-1H
Hold the sensor plates with folded tissue paper.
Move the tissue paper upward and downward to
remove the sample. Pushing strongly on the
sensor plates when moving the tissue upward, may
cause the sensor plates to bend.
Clean the temperature sensor in the same way.
Then, use tissue paper moistened with alcohol,
to remove any residual sample material.
SV-10A/SV-10H/SV-100A/SV-100H
Hold the sensor plate or temperature sensor with
tissue paper. Move the tissue paper downward to
remove the sample.
Then, use tissue paper moistened with alcohol,
to remove any residual sample material.
Clean the sample cup as necessary.
Unlock the cable connector before disconnecting the connection the cable.
How to unlock the cable connector
Sensor plate
Temperature
sensor
Sensor plate
Temperature
sensor