A&D Weighing SV-100H - Manual (Page 55)

53
S5t-b 0 Stable when within±5%
1 •
Stability band width
2 Stable when within±15%
When setting the auto hold
function, it can be set.
（
H-fnc 1）
Hld-t 0 15 second
1 • 30 second
2 45 second
Hold time
3 1 minutes
When setting the timer
mode function, it can be
set.（H-fnc 2）
Cp 0 • No comparison
Comparator mode 1 Comparison
bep- 0 • Off
Lo buzzer 1
On Sound the buzzer, when the displayed viscosity value
equal to or lower than the lower limit value that is set
bep- 0 • Off
OK buzzer 1
On Sound the buzzer, when the displayed viscosity value is
between the lower and upper limit value that is set
bep- 0 • Off
HI buzzer 1
On Sound the buzzer, when the displayed viscosity value
equal to or greater than the upper limit value that is set
Cp Hi
Upper limit value
Cp lo
Lower limit value
This function can be used with“Cp 1”.
Refer to comparator function
Iid
ID number output
Sets the ID number output
By setting“5-ed”, the ID
number output can be
added to measurement
data
Clr
Initialization
Restores the function settings and calibration data to the
factory setting.
Cladj
Date/Time Sets the order of the date (YMD,MDY,DMY) and the
date/time.
• Factory setting