AvMap GeoPilot II Plus - Manual (Page 20)

20
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENT’ + “GENERAL SETUP” + ‘ENT’ +
“LANGUAGE” + ‘ENT’
Choose the language you want and press ‘ENT’ again to confirm.
2.5 exTernAl ConneCTIonS
2.5.1 Internal/external GPS Source
The Geopilot II Plus has an internal GPS Receiver. Be sure the Fix Source is set to Internal GPS to
receive data from this internal receiver.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “FIX SETUP” + ‘ENTER’ + “FIX
SOURCE” + ‘ENTER’
Choose Internal GPS and press ‘ENTER’ to confirm. Otherwise if the Geopilot II Plus is using an
external NMEA0183 positioning source, set the Fix Source as External NMEA0183. The recognized
Input NMEA0183 messages are the following: GGA, GLL, GSA, GSV, HDG, HDM, HDT, PCMPA,
RMC, VHW, VTG (see Appendix E for more details on NMEA sentences).
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “FIX SETUP” + ‘ENTER’ + “FIX
SOURCE” + ‘ENTER’
Choose External NMEA0183 and press ‘ENTER’ to confirm.
Fig. 2.5.1 - External Input
2.5.2 nmeA outputs
The Geopilot II Plus can be connected to external equipment that accepts NMEA0183 data input.
Once attached, the output of NMEA formatted position information can be enabled in the following
manner:
> ‘MENU’ 1 sec. + “COMMUNICATIONS” + ‘ENTER’ + “NMEA OUTPUT” + ‘ENTER’
The default setting is Off. The Output NMEA0183 messages are the following: APA, APB, BOD,
BWC, GGA, GSA, GSV, GLL, HSC, RMA, RMB, RMC, VTG, WCV, XTE (see Appendix F for more
details on NMEA sentences) BOD, BWC, GGA, GLL, HSC, RMA, RMB, RMC, VTG, WCV, XTE (see
Appendix F for more details on NMEA sentences).
Fig. 2.5.2 - NMEA Connections