AvMap GeoPilot II Plus - Manual (Page 62)

62
Press ‘ENT’ to mark each item after checking is completed. If all the items of the list are not
checked upon exit a warning message appears on the screen that states the check-list has not been
completed. Press any key to accept.
11.3 Pre TAKe-off
>‘MENU’ 1 sec. + “CHECKLISTS” + ‘ENT’ + “PRE-TAKEOFF” + ‘ENT’
After pressing ‘ENTER’ select each item (Instruments, Fuel Tanks, Prop/Mixture, Fuel Pump, Engine
Gauges, Carb. Heat-Off, Doors/Belts, Flaps/Trim, Transponder, Radios). Press ‘ENT’ to mark each
item after checking is completed. If all the items of the list are not checked upon exit a warning
message appears on the screen that states the check-list has not been completed. Press any key to
accept.
11.4 CrUISe In flIGhT
>‘MENU’ 1 sec. + “CHECKLISTS” + ‘ENT’ + “CRUISE” + ‘ENT’
After pressing ‘ENTER’ select each item (Power as Required, Carburetor Heat Check, Mixture Lean,
Engine Parameters, Lights as Required, Electrical Load).
Press ‘ENT’ to mark each item after checking is completed. If all the items of the list are not
checked upon exit a warning message appears on the screen that states the check-list has not been
completed. Press any key to accept.
11.5 lAndInG
>‘MENU’ 1 sec. + “CHECKLISTS” + ‘ENT’ + “LANDING” + ‘ENT’
After pressing ‘ENTER’ select each item (Mixture, Prop/Mixture, Fuel Tanks, Fuel Pump, Carb. Heat,
Seat Belts, Trim, Flaps, Gear, Lights) .
Press ‘ENT’ to mark each item after checking is completed. If all the items of the list are not
checked upon exit a warning message appears on the screen that states the check-list has not been
completed. Press any key to accept.