Kenmore 385.15408 - Manual (Page 52)

SECTION VI. BUTTONHOLE
Buttonhole
(j) Pattern selector:
(2) Presser foot:
(D Thread tension:
(I)
Stitch length:
Sliding buttonhole foot
1 to 5
(0.25 to 1)
To adjust buttonhole stitch density
Set the stitch length dial between 0.25 and 1.0 to adjust
the buttonhole stitch density.
NOTE: Always check a buttonhole on a scrap of fabric to
make sure the adjustment satisfies you.
' Starting to sew I
Snap the buttonhole foot ( J) oh the presser foot: hoider.: :
Carefully mark the buttonhole length on the fabric.
Place the fabric under the foot, with .the buttonhole marking
running toward you: ;:;:
; i
Move the slider (A) toward you, so that the red arrow (C) on
the slider aligns with the start mark (B). Lower the presser
foot.
NOTEiThe markings on the slider are engraved in
centimeters.
BH
ill
J5E
Set the stitch selector at |] . Sew forward until you reach the ^
front mark of your buttonhole. Stop sewing at a left stitch. ^
4
54