Clover Electronics CDR 4170 - Manual (Page 28)

5.2 HOW TO SET UP
- Setup is possible in the LIVE mode and partly in the recording mode, not in the playback mode.
- Press
the SETUP button.
- Choose a setup item by using the UP/DOWN buttons and press the ENTER button.
- Choose the desired values with the ENTER button.
- Press the ESC button to exit.
5.3 ALARM
- Choose
the ALARM in the MAIN SETUP menu by using UP/DOWN buttons.
- Press
the ENTER button and the ALARM menu will be displayed.
- Press
the ESC button to exit.
5.3.1 ALARM
• Choose the ALARM in the ALARM menu with the UP/DOWN buttons.
• Select ON or OFF by pressing the ENTER button.
• ON should be selected for alarm recording.
5.3.2 ALARM HOLD / INPUT
• Choose the channel by using the UP/DOWN buttons.
• Press
the ENTER button to change the alarm hold time (1 to 15 seconds) by using the
UP/DOWN buttons.
• Select the ALARM INPUT using the LEFT/RIGHT buttons and choose ON or OFF by
using the ENTER button. N/O should be selected, and connected the N.O (Normally
Open) PIR sensor for alarm recording.
• Press the ESC button to exit.
5.3.3 ALARM OPTION
• Choose the ALARM OPTION in the ALARM menu with the UP/DOWN buttons.
• Press the ENTER button and the ALARM OPTION menu will be displayed.
5.3.4 ALARM REC
• Choose the ALARM REC in the ALARM OPTION menu by using the UP/DOWN buttons.
• Select ON or OFF by pressing the ENTER button.
• ON should be selected for alarm recording.
5.3.5 REC QUALITY
• Choose the REC QUALITY in the ALARM OPTION menu by using the UP/DOWN
buttons.
• Choose one quality among LOW, NORMAL, HIGH and VERY HIGH by repeatedly
pressing the ENTER button.
- 23 -