Clover Electronics CDR 4170 - Manual (Page 33)

5.5.6.1 IP MODE
• Choose the IP MODE in the IP CONFIGURATION menu with the UP/DOWN buttons.
• Choose DYNAMIC IP or STATIC IP by pressing the ENTER button.
DYNAMIC IP: The IP is automatically allocated via router. Therefore the IP address, subnet
mask and gateway address will be automatically allocated.
STATIC IP: This has to be set when the STATIC IP is used. The subnet mask and gateway
address has to be set as well.
5.5.6.2 IP ADDRESS
• Choose the IP ADDRESS in the IP CONFIGURATION menu with the UP/DOWN buttons
and press the ENTER button.
• Select the digits by using the LEFT/RIGHT buttons and change the values with the
UP/DOWN buttons.
• After completing, press the ENTER button to apply the IP ADDRESS setting to the
system.
5.5.6.3 SUBNET
• Choose the SUBNET in the IP CONFIGURATION menu with the UP/DOWN buttons and
press the ENTER button.
• Select the digits by using the LEFT/RIGHT buttons and change the values with the
UP/DOWN buttons.
• After completing, press the ENTER button to apply the SUBNETMASK setting to the
system.
5.5.6.4 GATEWAY
• Choose the GATEWAY in the IP CONFIGURATION menu with the UP/DOWN buttons
and press the ENTER button.
• Select the digits by using the LEFT/RIGHT buttons and change the values with the
UP/DOWN buttons.
• After completing, press the ENTER button to apply the GATEWAY setting to the system.
5.5.6.5 PORT
• The PORT is the TCP address of the program, which is used to connect to the network
viewer and has a range of 0000 to 9999.
• Choose the PORT in the IP CONFIGURATION menu with the UP/DOWN buttons and
press the ENTER button.
• Select the digits by using the LEFT/RIGHT buttons and change the values with the
UP/DOWN buttons.
• After completing, press the ENTER button to apply the PORT setting to the system.
- 28 -