Clover Electronics CDR 4170 - Manual (Page 42)

4. Attach the HDD to the removable HDD rack and secure it with the supplied screws as below.
5. Assemble and put the removable HDD rack back in it’s place.
6. Turn the power on and see if the HDD is being recognized.
6.2 INSTALL THE HDD2
The HDD2 (SLAVE) can be installed inside of the system.
The power switch must be turned off and unplug the power cord to prevent an electric shock may
happen.
1. Turn the power switch off and unplug the power cord.
2. Remove the cover by using driver.
(Remove the screws on both side and back of the product.)
3. Set the jumper setting to SLAVE on the HDD.
There are four holes on the bottom of the system. Attach the HDD2 to the bottom (Refer to the
below).
NOTE
If the HDD is not recognized after installing, please check the HDD jumper setting,
power cable and data cable connection.
CAUTION
TO INSTALL A HARD DISK DRIVE (HDD) FOR SLAVE, UNPLUG
THE AC POWER CORD AS THIS CAN RESULT IN A RISK OF
ELECTRIC SHOCK.
- 37 -