Clover Electronics CDR 4170 - Manual (Page 41)

10. To complete, click Add Host on the bottom.
11. After registration, go to the DDNS SET menu on the DVR.
12. Refer to section 5.11 DDNS in this manual for the next step.
Registration to CLOVERDVR.COM
1. Go to website www.cloverdvr.com
2. Select Insert New User.
3. Enter your ID and Password (up to 8 digits), and press Submit.
4. New ID will be created.
5. Press
Go Home.
6. Select View User.
7. Enter your ID and Password and press Submit.
8. Now you can see the ID, Domain and IP address.
9. After registration, go to the DDNS SET menu on the DVR.
10. Enter the registered ID to the HOST NAME and USER NAME in the DDNS SET
menu.
11. Refer to section 5.11 DDNS in this manual for the next step.
6. INSTALL THE HDD
6.1 INSTALL THE HDD1
DVR manufacturer already installed a 160GB of HDD1 as MASTER in the removable HDD rack.
Just in case, refer to the following explanation on how to install HDD (Hard Disk Drive).
CAUTION The power switch must be turned off before installing.
Removable HDD Rack
USB PAUSE
REC
ALRST PTZ BACKUP WTMK SETUP A-LIST SEARCH ESC STOP REW FF PLAY
AUTO ENTER QUAD PIP POP CH3 CH4 CH2 CH1 REC PLAY TIMER ALARM FULL POWER
1. Separate the removable HDD rack from the system.
2. Refer to the HDD manufacturer’s directions on how to set the jumper for master or slave when
assembling.
3. Make sure the power connector and the flat cable are properly connected.
- 36 -