Clover Electronics CDR 4170 - Manual (Page 30)

5.4.4 AREA
• Choose the AREA in the MOTION menu with the UP/DOWN buttons
• Press the ENTER button to create the motion detection AREA.
• Move the symbol “O” by using the UP / DOWN / LEFT / RIGHT buttons and select the
area where you would like to create, and press the ENTER button.
• To release the motion detection area, press the ENTER button after moving the symbol
“O” to the same area where you created.
• Press the ESC button to exit.
Created Motion
detection area
NOTE
The OSD or OSD+BUZZER and the motion detection AREA should be selected
for motion recording.
5.5 SYSTEM
- Choose the SYSTEM in the MAIN SETUP menu by using UP/DOWN buttons.
- Press the ENTER button and the SYSTEM menu will be displayed.
- Press the ESC button to exit.
5.5.1 TIME / DATE
• Choose the TIME/ DATE in the SYSTEM menu with the UP/DOWN buttons.
• Press the ENTER button, and the TIME /DATE SET menu will be displayed.
5.5.1.1 TIME FORMAT
• Choose the TIME FORMAT in the TIME /DATE SET menu with the UP/DOWN buttons.
• Select the 12 HOURS or 24 HOURS mode by using the ENTER button.
5.5.1.2 TIME
• Choose the TIME in the TIME /DATE SET menu with the UP/DOWN buttons.
• Press the ENTER button to make TIME changes.
• Select Hour/Min/Sec by using the LEFT/RIGHT buttons and change the values by using
the UP/DOWN buttons.
- 25 -