Clover Electronics CDR 4170 - Manual (Page 43)

HDD2 ATTACHING POINT
4. Secure the HDD with the supplied screws as below.
5. Connect the power connector and the flat cable to the HDD.
6. Reassemble the cover.
7. Turn the power on and see if the HDD is being recognized.
NOTE
Be sure that the jumper setting is correct. If not, the system will not recognize the
additional HDD (SLAVE).
FIX SCREW
NOTE
Be sure that the power connector and the flat cable are properly connected.
NOTE
After installing the additional HDD, formatting the new HDD should be performed.
See 5.5.2 Hard Drive for more details.
- 38 -