Clover Electronics CDR 4170 - Manual (Page 31)

• To apply the setting, press the ENTER button.
5.5.1.3 DATE FORMAT
• Choose the DATE FORMAT in the TIME /DATE SET menu with the UP/DOWN buttons.
• Select the DATE FORMAT by pressing the ENTER button.
There are three formats to display the time and date as follows.
MM / DD / YYYY: For U.S.A.
YYYY / MM / DD: For Asian Countries.
DD / MM / YYYY: For European Countries.
5.5.1.4 DATE
• Choose the DATE in the TIME /DATE SET menu with the UP/DOWN buttons.
• Press the ENTER button to make DATE changes.
• Select Month/Day/Year by using the LEFT/RIGHT buttons and change the values by
using the UP/DOWN buttons.
• To apply the setting, press the ENTER button.
• Press the ESC button to exit.
5.5.2 HARD DISK
■ When you install the new Hard Disk Drive (HDD), it should be formatted
before recording. Formatting is possible only when the system is in the
LIVE mode.
■ Factory installed a 160GB of HDD as Master (jumper setting) in the
removable HDD cradle.
• Maximum 2 HDDs can be connected to the system
• Choose
the HARD DISK in the SYSTEM menu with the UP/DOWN buttons.
• Press the ENTER button, and the HARD DISK menu will be displayed.
• Refer to section 6.1 in regards to HDD installation.
5.5.2.1 HDD1
• Shows the available space and the used space of HDD1.
• Select the HDD1 in HDD DISK menu to format by using the UP/DOWN buttons and press
the ENTER button, and the HDD FORMAT: YES, NO will be displayed. If YES is selected
by using the LEFT/RIGHT/ENTER button, it starts to formatting or select NO for going
back to the previous mode.
5.5.2.2 HDD2
• Shows the available space and the used space of HDD2.
• Select
the HDD2 in HDD DISK menu to format by using the UP/DOWN buttons and press
the ENTER button, and the HDD FORMAT: YES, NO will be displayed. If YES is selected
- 26 -