Kenwood COMPACT DISC DIGITAL AUDIO UD-703 - Manual (Page 35)

Relay playback
U se the follow ing procedure to play tapes in decks A and B
alternately.
UD-703/753 (En)
if __o
-0@ ® oVoV oop_
r
0 0 (B)0@
Load tapes.
Start playback.
•The tape sides indicated by the tape transport direction indicators will be
played.
Each press switches the modes as follows.
® "cio" .........Relay playback does not occur with this position,
@ "Tzt"........ . Playback stops after having played one side on each of
tapes in decks A and B.
— (3) " z = d " ............ .The two sides of tapes in decks A and B will be played
repeatedly
r 0 DOLBY NR “B".. .......... .General NR.
d) DOLBY NR “C” ............ NR with higher performance.
(D DOLBY NR “OFF”
(no indication).................. Dolby NR is not used.
• Select the Dolby NR mode according to the recording condition of the tape. •
• Relay playback starts with the deck corresponding to the pressed key.
Dolby Noise Reduction (NR)
The Dolby NR system is used to minimize the hiss noise heard when
playing tape. The system has the B type and C type, and the same type
should be used in recording and playback to obtain the noise reduction
effect.
When you record a tape, it is recommended to write the type used, "B"
or "C", on the cassette label.
Dolby B NR: Generally-used Dolby NR.
Dolby C NR: Features a higher noise reduction effect than the B type.
The use of Dolby C NR is recommended if you record tapes to be played
on this unit.
Transport direction indicators
The ◄ and ► indicators indicate the current direction in which the tape
advances when playback or recording is started automatically by the easy
operation function, etc. This direction is the direction stored in memory
when the tape was last stopped.
(To change the direction, press the ► key for the opposite direction then
press the ■ key.)
Transport direction indicators