Comtrol Modbus TCP User Guide User Manual
Page 102
Advertising
102 - Appendix A. Programming the PLC via Concept
DeviceMaster UP Modbus/TCP User Guide: 2000447 Rev. I
Setting up and Running the Concept Example Programs
24. Start the processor by selecting Online->Online Control Panel…
In the Online Control Panel, select Invoke Constant Sweep…
a.
Verify the 4x register is 2999. (This is an unused
register.)
b.
Verify the sweep rate is 10 msec.
c.
Select OK.
d.
Select Start Controller.
e.
Select Close.
25. Observe the data being transmitted and received.
Advertising