Comtrol Modbus TCP User Guide User Manual
Page 98
Advertising
98 - Appendix A. Programming the PLC via Concept
DeviceMaster UP Modbus/TCP User Guide: 2000447 Rev. I
Setting up and Running the Concept Example Programs
e.
Select OK.
16. In the PLC Memory Partition pane:
a.
Verify that your PLC has sufficient memory. The example program requires 3000 holding registers.
b.
Select OK.
17. In the Config Extensions->Ethernet/ IO Scanner pane:
a.
Select your method of specifying an IP address.
If you are specifying an IP Address:
•
Enter the PLC IP Address under Internet Address.
•
Enter the Gateway address.
•
Enter the Subnet Mask.
b.
Verify the Master Module is configured properly.
Advertising