Overview, Chapter 3. embedded, Chapter 3. embedded configuration pages – Comtrol Modbus TCP User Guide User Manual
Page 33
DeviceMaster UP Modbus/TCP User Guide: 2000447 Rev. I
Chapter 3. Embedded Configuration Pages- 33
Chapter 3. Embedded Configuration Pages
This chapter provides detailed information about the embedded web pages for serial and Ethernet device
configuration. Ethernet devices are configured via an Ethernet TCP/IP socket connection. The latest Modbus/
TCP firmware must be installed before you can configure network or serial/socket port characteristics. For
firmware installation and setup information, see the
DeviceMaster UP Hardware Installation and
Configuration Guide
or the PortVision DX help system.
Use the
Modbus/TCP Interface Configuration Quick Start
to locate configuration procedures for your site and
use this chapter as a reference if you need information about specific fields. The Interface Configuration Quick
Start is intended to provide you with a way to quickly configure DeviceMaster UP for your devices.
3.1. Overview
The following overview shows how to access the DeviceMaster UP Server Configuration embedded web page
and configure serial and Ethernet device interfaces.
If you have not configured the network information into the DeviceMaster UP during initial setup, you must
configure the network information before configuring serial/socket port characteristics. See the
DeviceMaster
UP Hardware Installation and Configuration Guide
or the PortVision DX help system for help configuring
the network settings.
1.
From PortVision DX, highlight the DeviceMaster UP that you want to configure and select Webpage.
Note: Optionally, enter the IP address of the device in the Address box of your web browse.
2.
Select the appropriate
procedure for your
environment.
Serial Device
a.
Select Serial Device
Configuration.
b.
Select the appropriate
port to access the Edit
Serial Port Configuration
page for that port.
c.
(Page 35) as required for
your site.
Ethernet Device
a.
Select Ethernet Device
Configuration.
b.
Select the appropriate
socket to access the Edit
Socket Port Configuration
page for that port.
c.
(Page 42) as required for your site.
3.
Select Submit to commit the changes and repeat for each port.
4.
Appendix A. Programming the PLC via Concept
on Page 85 to complete the DeviceMaster UP
installation.