Comtrol 500 DeviceMaster User Manual
Page 15
Hardware Installation
DeviceMaster 500 User Guide: 2000501 Rev. A - 15
Hardware Installation
3.
Plug the screw
terminal power
connector into JP1
on the
DeviceMaster 500
by aligning the
scalloped sides.
4.
Apply power to the
DeviceMaster 500.
5.
Verify the Status
LED has
completed the boot
cycle and network
connection for the
DeviceMaster 500
is functioning
properly using the
table below.
The LEDs are located between the RJ45 connector and the power terminal
block.
6.
Go to
on Page 19 for default network settings and how to
configure the DeviceMaster 500 for use.
LED Descriptions
Status
When lit, the amber Status LED (D1) on the
DeviceMaster 500 indicates the devices is fully powered
and has completed the boot cycle.
Note: The Status LED flashes for approximately 15
seconds while booting. When the Bootloader
completes the cycle, the LED has a solid, steady
light that blinks approximately every 30 seconds.
Link/Act
When lit, the red Link/Act LED (D2) indicates a
working Ethernet connection.
Duplex
When lit, the red Duplex (D3) LED indicates full-duplex
activity.
100
When lit, the red 100 (D4) LED indicates a working 100
MB Ethernet connection (100 MB network, only). If the
LED is not lit, it indicates a 10 MB Ethernet
connection.
LEDs
JP1