Comtrol 500 DeviceMaster - Manual (Page 61)

Hardware Specifications DeviceMaster 500 User Guide: 2000501 Rev. A - 61
Hardware Specifications
External Power Supply Specifications
This subsection discusses information that you may need if you wish to use your
own external power supplies
• Power Supply for the 1-Port on Page 61
• Power Supply for the 4-Port on Page 61
Power Supply for
the 1-Port This table provides specifications for the power
supply shipped with the DeviceMaster 500 1-port.
Note: The embedded model is not shipped with a
power supply.
This table provides the specifications, if you
intend on using your own power supply.
Note: The embedded model is not shipped with a power supply.
Power Supply for
the 4-Port This table provides the specifications for the power
supply shipped with the DeviceMaster 500 4-port.
This table provides the specifications, if you intend
on using your own power supply.
Comtrol Power Supply: 5-30VDC
Input line frequency
Input line voltage
Output voltage
Output current
43-63 Hz
90-260 VAC
24VDC
500 mA @ 24VDC
External Power Supply: 5-30VDC
Output voltage†
Current†
Power
5-30VDC
100 mA (Min) @ 24VDC
2.5 W
† Any power supply that meets current
consumption, voltage, power, and connector
pinouts requirements can be used.
Earth Gnd
Return
Positive
5-30VDC
+
-
Wire gauge:
AWG 12-22
Screw Terminal Connector
(included with the 1-port
enclosed model)
Comtrol Power Supply
Input line frequency
Input line voltage
Output voltage
Output current
47 - 63 Hz
90 - 260 VAC
24VDC
500 mA @ 24VDC
External Power Supply
Output voltage†
Current†
Power
9-30VDC
200 mA (Min) @ 24VDC
4.8 W
† Any power supply that meets current consumption, voltage,
power, and connector pinouts requirements can be used.
+VDC
V Return - GND
Shield GND
Housing Molex P/N:
39-01-4030
Pins Molex P/N:
44485-1211