Comtrol 500 DeviceMaster - Manual (Page 9)

Hardware Installation DeviceMaster 500 User Guide: 2000501 Rev. A - 9
Hardware Installation
Installation Overview
The DeviceMaster 500 enables communications with serial devices over an
Ethernet network. The DeviceMaster 500 provides for remote management,
configuration, and connectivity through its 10/100BASE–T Ethernet connection.
Use the links below to locate installation procedures for the following models:
Ports DeviceMaster 500 Installation Procedure
1
DB9 serial port with one
Ethernet port
1-Port Installation on Page 10
1 Embedded system 1-Port Embedded Installation on Page 12
4†
DB9 serial ports with two
Ethernet†† ports
4-Port Installation on Page 16
† DeviceMaster 500 4 -port models also include DB9 to RJ45 adapters.
†† One of the Ethernet ports on the DeviceMaster 500 4-port is a built-in
downstream port for daisy-chaining DeviceMaster 500 systems or other
network-ready devices.
Default Network Settings
IP address:
192.168.250.250
Subnet mask:
255.255.0.0
Gateway address:
192.168.250.1