Futaba 12FG - Manual (Page 106)

106
<Functions of Model Menu (Helicopter Functions)>
S1 button
EDIT button
EDIT dial
ŏ3XVKWKHS1EXWWRQIRU
VHFRQGWRUHWXUQWRWKH
KRPHVFUHHQ
ŏ7XUQ WKH EDIT  GLDO WR
PRYHRQWKHVFUHHQ
ŏ6 H O H F W  W K H  I X Q F W L R Q
QDPH DQG UHWXUQ WR WKH
S U H F H G L Q J  V F U H H Q  E \
SXVKLQJWKHEDITEXWWRQ
MODEL MENU (HELICOPTER)
This section contains information on the
commands that apply to helicopters only. For
instructions on Airplanes and Sailplanes, refer to
the sections pertaining to those aircraft.
Use the Model Type function in the Linkage
Menu to select the swash type matched to the
fuselage beforehand.
Also, add flight conditions at the Condition
Select screen if necessary before setting the model
data at each function. (Up to 8 conditions can be
used)
The AFR function, Dual rate function and other
functions common to all model types, are described
in a separate section.
Model Menu functions (helicopter) list
PIT CURVE: $GMXVWVUHVSRQVHLQGLIIHUHQWÀLJKWFRQGLWLRQV
THR CURVE: Throttle curve and hovering trim adjustment
ACCELERATION: Allows a brief "overload" in response to sudden throttle and pitch commands
THR HOLD: Moves the throttle to idle during autorotation
SWASH MIX: Compensates for each control response
THROTTLE MIX: Compensates for power loss when cyclic applied
PIT to NEEDLE: $GMXVWVUHVSRQVHFXUYHLQGLIIHUHQWÀLJKWFRQGLWLRQV
PIT to RUD: Handles torque changes from pitch angle inputs
GYRO: Used to switch gyro sensitivity
GOVERNOR: Used to switch RPM of the helicopter’s head
To activate/deactivate Condition Hold:
0RYHWKHFXUVRUWR>&21'+2/'@
6HW WKH WKURWWOH VWLFN ORZHU WKDQ
WKH  SRLQW DQG SXVK WKH (',7
EXWWRQ WR DFWLYDWHGHDFWLYDWH WKH
FRQGLWLRQKROGIXQFWLRQ
*Refer to for condition hold function details.
*Condition hold operation is displayed.
ŏ 6HOHFW WKH >02'(/@ DW WKH KRPH VFUHHQ
DQG FDOO WKH PRGHO PHQX VKRZQ EHORZ E\
SXVKLQJWKH(',7EXWWRQ
ŏ 8VH WKH (',7 GLDO WR VHOHFW WKH IXQFWLRQ \RX
ZDQW WR VHW DQG FDOO WKH VHWXS VFUHHQ E\
SXVKLQJWKH(',7EXWWRQ
ŏ3XVK WKH S1 EXWWRQ WR
FDOOQH[WSDJH