Futaba 12FG - Manual (Page 59)

59
<Functions of Linkage Menu>
S1 button
EDIT button
EDIT dial
ŏ3XVKWKHS1EXWWRQIRU
VHFRQGWRUHWXUQWRWKH
KRPHVFUHHQ
ŏ7XUQ WKH EDIT  GLDO WR
PRYHRQWKHVFUHHQ
ŏ6 H O H F W  W K H  I X Q F W L R Q
QDPH DQG UHWXUQ WR WKH
S U H F H G L Q J  V F U H H Q  E \
SXVKLQJWKHEDITEXWWRQ
SERVO-REVERSE 8VHWRUHYHUVHWKHWKURZGLUHFWLRQ
Servo Reverse changes the direction of an
individual servo’s response to a control stick
movement.
For CCPM helicopters, be sure to read the
section on Swash AFR before reversing any servos.
With CCPM helicopters, always complete your
servo reversing prior to any other programming.
If you use pre-built Airplane/Sailplane functions
Servo reversing procedure
*After linkage of a new model is complete, check whether or
not each servo is connected to the correct channel.
*Next, determine whether you need to reverse any channels
by moving each stick.
 8VH WKH (',7 GLDO WR PRYH WKH FXUVRU WR WKH
FKDQQHO \RX ZDQW WR UHYHUVH DQG SXVK WKH
(',7EXWWRQWRVZLWFKWRWKHGDWDLQSXWPRGH
7XUQWKH(',7GLDODQGFKDQJHWKHGLVSOD\WR
>5(9(56(@ RU>1250$/@ 
*The display blinks.
 :KHQ WKH (',7 EXWWRQ LV SXVKHG VHUYR
RSHUDWLRQ LV UHYHUVHG 2SHUDWH (',7 GLDO RU
6EXWWRQWRVWRSUHYHUVDO
*Repeat the operation above for each channel that must be
reversed.
that control multiple servos, it may be confusing
to tell whether the servo needs to be reversed or a
setting in the function needs to be reversed. See the
instructions for each specialized function for further
details. Always check servo direction prior to every
ÀLJKWDVDQDGGLWLRQDOSUHFDXWLRQWRFRQ¿UPSURSHU
model memory, hook ups, and radio function.
(The display screen is an example. The screen
depends on the model type.)
ŏ6HOHFW>6(5925(9(56(@DWWKHOLQNDJHPHQXDQG
FDOOWKHVHWXSVFUHHQVKRZQEHORZE\SXVKLQJWKH
(',7EXWWRQ
ŏ3XVK WKH S1 EXWWRQ WR
FDOOQH[WSDJH