Futaba 12FG - Manual (Page 111)

111
<Functions of Model Menu (Helicopter Functions)>
Normal Curve Idle-up 1 Curve Idle-up 2 Curve
Ɣ7KURWWOH&XUYH ([DPSOH
The curves shown below are created by using
the point curve type and inputting the data of the
5 points 0% (low side), 25%, 50% (center), 75%,
100% (high) side at each condition. They are
created by reducing the number points of the line
to 5. When actually creating a curve, enter the data
VSHFL¿HGSHUWKHDLUFUDIW RUWKHUHIHUHQFHYDOXH 
*For a description of the curve creation method, see the
description at the back of this manual.
Curve setting examples
Throttle Hover trim
The Throttle Hover trim setup screen can be called from the THR Curve setup screen.
The Throttle Hover function trims the throttle
near the hovering point. Normally, use it with
hovering conditions. Changes in rotor speed
accompanying changes in the temperature,
humidity, and other flight conditions can be
trimmed. Adjust the throttle so that rotor rotation is
most stable. More delicate trimming is also possible
by using this function along with the Hover Pitch
function.
Setting method
ŏ:KHQXVLQJWKHKRYHULQJ QRUPDO FRQGLWLRQ
RQO\ VZLWFK WKH JURXS PRGH WR WKH VLQJOH
PRGH LQLWLDOVHWWLQJ DQGPDNHWKHVHWWLQJV
ŏ6HWWKHIXQFWLRQWR$&7 >21@ 
ŏ6HOHFWWKHDGMXVWPHQWNQRE
 6HOHFWLRQH[DPSOH 5'
ŏ 7KH WULP RSHUDWLRQ PRGH 0RGH  &750
1250 FDQEHVHOHFWHG
 CTRM mode: 0D[LPXP UDWH RI FKDQJH
Q H D U  F H Q W H U  E \  F H Q W H U  W U L P  R S H U D W L R Q
UHFRPPHQGHG
 N O R M m o d e : 1 R U P D O  W U L P  K R U L ] R Q W D O
PRYHPHQWWULP RSHUDWLRQ
ŏ7ULPDGMXVWPHQWUDQJH 5DQJH VHWWLQJ
 :KHQWKHYDOXHLVPDGHVPDOOWULPDFWVRQO\
QHDUWKHFHQWHU
ŏ 7KH WULP UDWH FDQ EH DGMXVWHG DQG WKH
RSHUDWLRQGLUHFWLRQFDQEHVHW
ŏ6HWVWKHGLDOXVHG