Futaba 12FG - Manual (Page 22)

22
<Basic Operation>
BASIC OPERATION
How to charge the Ni-MH battery HT6F1700B
for the transmitter and the Ni-Cd battery
NR4F1500 for the receiver
Danger
The Ni-MH battery HT6F1700B is only for
your T12FG. Do not use this battery for other
equipment.
Be sure to use the attached special charger to
charge the battery.
*If you take out the Ni-MH battery HT6F1700B from the
transmitter, you can use the optional quick charger CR-2000
corresponding to Ni-MH battery.
[Method of charging battery]
*Connect to AC outlet
specified.
ƔSpecial charger
Transmitter Batt.
Charging display Receiver Batt.
Charging display
To T12FG charge
connector
To receiver battery
1. Connect the special charger to the wall
socket (AC outlet).
2. Connect the connectors to the NR4F1500
N i C d b a t t e r y a n d / o r T 1 2 F G c h a r g i n g
connector.
&RQ¿UPWKDWHDFKFKDUJLQJLQGLFDWRU/('ODPSLVRQ
*Turn off the transmitter while charging the battery.
3. Remove the battery after 15 hours.
*Battery charging will not automatically stop. Remove the
battery and transmitter from the charger and remove the
charger from the wall socket.
*It is recommended to reactivate the battery by cycling
several times if the battery has not been used for a long
period.
*In case of Ni-MH/NiCd battery, you may find the poor
performance of the battery if you have used the battery only
for a short period or if you repeat charging while the battery
is not fully discharged. It is recommended to discharge the
battery to the recommended level after your usage. It is also
recommended to charge the battery just before your usage.
Battery Charging
Before charging batteries, read the "Cautions for handling battery and battery charger" in the section "Ni-
MH/Ni-Cd Battery Safety and Handling Instructions".