Futaba 12FG - Manual (Page 58)

58
<Functions of Linkage Menu>
S1 button
EDIT button
EDIT dial
ŏ3XVKWKHS1EXWWRQIRU
VHFRQGWRUHWXUQWRWKH
KRPHVFUHHQ
ŏ7XUQ WKH EDIT  GLDO WR
PRYHRQWKHVFUHHQ
ŏ6 H O H F W  W K H  I X Q F W L R Q
QDPH DQG UHWXUQ WR WKH
S U H F H G L Q J  V F U H H Q  E \
SXVKLQJWKHEDITEXWWRQ
SUB-TRIM 6HWWLQJRIQHXWUDOSRVLWLRQRIHDFKVHUYR
(The display screen is an example. The screen
depends on the model type.)
The Sub-Trim function is used to set the servo
neutral position, and may be used to make fine
adjustments to the control surface after linkages
and pushrods are hooked up. When you begin to set
up a model, be sure that the digital trims are set to
their center position.
Sub trim adjustment
 8VH WKH (',7 GLDO WR PRYH WKH FXUVRU WR WKH
FKDQQHO \RX ZDQW WR DGMXVW DQG SXVK WKH
(',7EXWWRQWRVZLWFKWRWKHGDWDLQSXWPRGH
$GMXVWE\WXUQLQJWKH(',7GLDO
 ,QLWLDOYDOXH 
 $GMXVWPHQWUDQJH a VWHSV
(When the EDIT button is pushed for 1 second, sub trim is
reset to the initial value.)
*Before sub trim adjustment, adjustment of the linkage so that
control surfaces need not use sub trim as much as possible is
very important.
5HSHDWWKLVSURFHGXUHIRUHDFKFKDQQHO
ŏ6HOHFW>68%75,0@DWWKHOLQNDJHPHQXDQGFDOOWKH
VHWXS VFUHHQ VKRZQ EHORZ E\ SXVKLQJ WKH (',7
EXWWRQ
ŏ3XVK WKH S1 EXWWRQ WR
FDOOQH[WSDJH