Futaba 12FG - Manual (Page 7)

7
Introduction
Ni-MH/Ni-Cd Battery Safety and Handling instructions
It is important to understand the operating characteristics of Ni-MH/Ni-Cd batteries. Always read the specifications
printed on the label of your Ni-MH/Ni-Cd battery and charger prior to use. Failure to follow the proceeding precautions
can quickly result in severe, permanent damage to the batteries and its surroundings and possibly result in a FIRE!
IMPORTANT PRECAUTIONS
Do not attempt to disassemble Ni-MH/Ni-Cd packs or cells.
Do not allow Ni-MH/Ni-Cd cells to come in contact with moisture or water at any time.
Always provide adequate ventilation around Ni-MH/Ni-Cd batteries during charge, discharge, while in use, and
during storage.
Do not leave a Ni-MH/Ni-Cd battery unattended at any time while being charged or discharged.
Do not attempt to charge Ni-MH/Ni-Cd batteries with a charger that is NOT designed for Ni-MH/Ni-Cd batteries,
as permanent damage to the battery and charger could result.
Always charge Ni-MH/Ni-Cd batteries in a fireproof location. Do not charge or discharge Ni-MH/Ni-Cd batteries
on carpet, a cluttered workbench, near paper, plastic, vinyl, leather or wood, or inside an R/C model or full sized
automobile! Monitor the charge area with a smoke or fire alarm.
Do not charge Ni-MH/Ni-Cd batteries at currents greater than the “1C” rating of the battery (“C” equals the rated
capacity of the battery).
Do not allow Ni-MH/Ni-Cd cells to overheat at any time! Cells which reach greater than 140 degrees Fahrenheit
(60
o C) should be placed in a fireproof location.
Ni-MH/Ni-Cd cells will not charge fully when too cold or show full charge.
It is normal for the batteries to become warm during charging, but if the charger or battery becomes excessively hot
disconnect the battery from the charger immediately!! Always inspect a battery which has previously overheated for
potential damage, and do not re-use if you suspect it has been damaged in any way.
Do not use a Ni-MH/Ni-Cd battery if you suspect physical damage has occurred to the pack. Carefully inspect the
battery for even the smallest of dents, cracks, splits, punctures or damage to the wiring and connectors. DO NOT
allow the battery’s internal electrolyte to get into eyes or on skin—wash affected areas immediately if they come in
contact with the electrolyte. If in doubt, place the battery in a fire-proof location for at least 30 minutes.
Do not store batteries near an open flame or heater.
Do not discharge Ni-MH/Ni-Cd batteries at currents which exceed the discharge current rating of the battery.
Always store Ni-MH/Ni-Cd cells/packs in a secure location away from children.
Secure Digital (SD) Memory Card Handling Instructions
(SD card is not included with this set)
IMPORTANT!
Use only the Futaba special charger included with this set or other chargers approved by Futaba to charge the
Ni-MH batteries in the 12FG transmitter and Ni-Cd batteries included with this set.
Never remove the SD card or turn off power while
entering data.
Never store the SD card where it may be subject to
strong static electricity or magnetic fields.
Do not expose the SD card to direct sunlight, excessive
humidity or corrosive environments.
Do not expose the SD card to dirt, moisture, water or
fluids of any kind.
Always hold the SD card by the edges during installa-
tion and removal.
Be certain to insert the SD card in the correct direction.