Tcp/ip network function settings, Index top contents – Canon W8400 User Manual
Page 319
5- 23
Macintosh Network Settings
Chapter 3
Printing by Objective
Chapter 7
Operating the
Function Menu
TCP/IP Network Function Settings
Confirm the operating system TCP/IP function settings
for the Remote UI and PI Print connection, Canon IP
(GARO) connection, or Zeroconf connection.
z
For Mac OS 8.6/9.x
Use Chooser and TCP/IP on the Control Panels to
confirm the TCP/IP network settings.
Important
z
If a static IP address has already been allocated to the
Macintosh computer you are using, you can keep
using the current settings. No further configuration is
required. For network settings, consult your network
administrator.
z
To connect to the printer using IP Print (auto), the
printer and computer need to be connected to the
same network segment. It is not possible to connect to
a printer on another network via a router using IP Print
(auto). For network settings, consult your network
administrator.
z
If the server cannot be found when Using DHCP
Server is selected, then “169.254.xxx.xxx” is set as
the Link Local Address. In this case, start the DHCP
server on the network, or consult your network
administrator.
1
Confirm that TCP/IP connection method is
set to Ethernet.
Start TCP/IP on Control Panels.
For the Connect via select Ethernet.
Set Using DHCP Server for Configure.
Close TCP/IP to save the setting.
This completes the TCP/IP network settings for a
Macintosh.