Keri Systems Doors16 - Manual (Page 37)

Keri Systems, Inc. Doors™ Users Guide
01821-001 October 1998
Revision 2.1 Page 37
Setup/Verify Network Communication
The Setup/Verify Network Communication section describes the process for configuring the
Doors communication parameters to meet those of the host computer and then verifying that
basic communication is indeed happening between the host computer and all the controllers
on the access control network.
Set Communication Parameters
The following tasks are described in this section. All four tasks must be performed to properly
set the communication parameters.
• Set the COM port.
• Set the communication speed.
• Set the modem parameters (if the access control network requires modems for remote
access).
• Save the communication parameters and restart the program to configure Doors.
Set the COM Port
The COM port that is used for communication between the host computer and the access
control network must be identified.
1. Click on the Setup
⇒
System pull-down menu or click on the button on the tool
bar.
2. The first time the Setup menu is entered (and every time until system configuration is
complete) the Setting Up The System window will appear as a reminder that system
configuration needs to be performed (see Figure 6).
Figure 6 – Setting Up The System Reminder
3. Click on the button. The Setup/System window appears (see Figure 7).