Keri Systems Doors16 - Manual (Page 68)

Doors™ Users Guide Keri Systems, Inc.
October 1998 01821-001
Page 68 Revision 2.1
3. Locate the "Reader Enabled" column and click on the ON button corresponding to the
selected controller/door. The ON button will toggle to OFF and its color will change from
green to red. For example, locate the "Stockroom Door - Reader Enabled" cell and click
on the ON button.
4. The resulting window should look similar to Figure 36.
Figure 36 – Disabling/Enabling a Reader
5. Enabling a reader is simply the opposite of disabling a reader. Locate the reader to be
enabled. Click on the OFF button corresponding to the selected controller/door. The OFF
button will toggle to ON and its color will change from red to green. For example, locate
the "Stockroom Door - Reader Enabled" cell and click on the OFF button. The window
should again appear similar to the window in Figure 35.
6. Once changes have been made, click on the button. If the changes are not saved
before clicking any other button or exiting the system setup window, the data entered is
lost and must be re-entered.
7. Now update the access control network with the new information. Click on the
button on the tool bar (for details on the update process refer to the Update the Network
section found later in this users guide).
Set a Door Unlock Time
The door unlock time is the number of seconds the controller holds the door lock relay in the
unlocked position to allow ingress or egress. A timer with this value begins counting once the
card is presented to the reader. When the timer ends, the door lock relay resets to the locked
position; the default time is 5 seconds (if a door status switch is used, the door lock also resets
once the door is opened).
1. To set a door’s unlock time, click on the Setup
⇒
System pull-down menu or click on the
tool bar button. Then click on the Doors tab. Building off the previous section, the
window found in Figure 35 appears.
2. Scan down the door name and controller/door address columns and locate the door to
have an unlock time assigned.
3. Locate the "Unlock Time" column and click on the cell corresponding to the selected
controller/door. Type the desired unlock time; the existing value will be overwritten. For
example, a back door may need to stay unlocked longer than other doors. Locate and
click on the "Back Door - Unlock Time" cell and type 15. This will set the unlock time
for this door to 15 seconds.